-bcm4329: Add latest firmware (4.218.248.6) from Nvidia’s tegra-10.11.1.1
-defconfig: set EXT4 as in-built
-defconfig: add in Network,IPV4/6,Netfilter,and Queuing options
-backport: support for lzma-compressed kernel images on arm
-defconfig: switch to LZMA compression
Known Issues:
-When waking up from standby/sleep, the clock in the status bar will change when RTC changes in the next minute.
-If your BT Audio device does not work with the the stack that comes within your ROM, no audio will be sent to your device, and once you disconnect, you will need to plug in a 3.5mm jack and unplug to get audio back.
**Devices that don’t work: Jabbra.
**Devices that do work: Parrot audio, Jawbone.
Things to do:
-backport AOSP’s frequency scaling
-pull further scheduler|i/o changes in
-clean up the barrage of warnings from TapnTap/Viewsonic’s patch
——–
-XTRA contains:
*ondemand governor default; only interactive,ondemand and userspace governors
*CFQ I/O Scheduler
*some more cgroup options
*namespaces support (excluding network)
*Tegra NvEC embedded controller driver
*erratas 430973, 458693 and 460075 applied
ViewSonic Gtab:
boot-cm_2632.28_gtab-xtra-vfpv3_fp-011011.zip
Download: boot-cm_2632.28_gtab-xtra-vfpv3_fp-011011.zip
Malata Zpad:
boot-cm_2632.28_zpad-xtra-vfpv3_fp-011011.zip
Download: boot-cm_2632.28_zpad-xtra-vfpv3_fp-011011.zip
Note (from proengin):
You should be on CWM0.8 (bekit)
The bootloader.bin must match CWM0.8 (bekit)
<><><><>
lib-2632.28.tar.gz (kernel modules)
Download: lib-2632.28.tar.gz
——–
Source:
http://github.com/pershoot/gtab-2632
http://nv-tegra.nvidia.com/gitweb/?p=linux-2.6.git;a=summary
http://git.kernel.org/?p=linux/kernel/git/stable/linux-2.6.32.y.git;a=summary
http://github.com/pershoot/vision-2632
——–
Instructions:
Flash the .zip through recovery
To use one of the kernel modules:
Pull the one you want from lib-2632.28.tar.gz (winrar can open this),
adb remount
adb push MODULE.ko /system/lib/modules/2.6.32.28-cyanogenmod/
adb shell chmod 644 /system/lib/modules/2.6.32.28-cyanogenmod/MODULE.ko
adb shell insmod /system/lib/modules/2.6.32.28-cyanogenmod/MODULE.ko
Note:
You can download gscript lite from the Market, and put the insmod line in there, and tap when you want to insert it and use its functionality.