-msm72k_udc.c: remove conditional phy_reset
-set FIQ_DEBUGGER to N

-merged (from android.git.kernel.org common):
7877eabcb8860f4112eff7a77ba502dcb8b6fe6a (ARM: Add fiq_glue)
438e0964cb791cfb61c1da2333b113be483ae531 (ARM: Add generic fiq serial debugger)
a8c11a046422bbcfa383c580ea4c85888517c115 (ARM: fiq debugger: Add tty to fiq debugger)

Note:
If you want to use NFS, please push the contents of the .zip below to kernel/fs within /system/lib/modules/KERNEL_MODULES_FOLDER

nfs_32b.zip
nfs_32a.zip

Known Issues:
-For builds lower then Froyo (i.e. Eclair), when USB is plugged in, vold will SIGSEV.
-If you face issues charging from the wall, please use USB to charge.
-After unplugging from USB, please reboot to prevent excessive battery drain. *This is being worked on.

——–

-XTRA contains:
*ondemand governor default; only performance,interactive,ondemand and userspace governors
*BFQ I/O Scheduler
*some more cgroup options
*namespaces support (excluding network)
*v4 block device and data integrity support
*errata 411920 applied

32B:
boot-cm_2635.7_ds_32b-oc-uv-xtra-fp-100510.zip
Download: boot-cm_2635.7_ds_32b-oc-uv-xtra-fp-100510.zip

32A:
boot-cm_2635.7_ds_32a-oc-uv-xtra-fp-100510.zip
Download: boot-cm_2635.7_ds_32a-oc-uv-xtra-fp-100510.zip

——–

Source:
http://github.com/pershoot/kernel-2635
http://github.com/CyanogenMod/cm-kernel
http://github.com/pershoot/ds-kernel-2635
http://github.com/pershoot/ds-kernel-32a-2635
http://github.com/toastcfh/htc-2.6.27-heroc
http://github.com/pershoot/ds-kernel-32a
http://github.com/bcrook/32A-EBI1
http://android.git.kernel.org/?p=kernel/experimental.git;a=shortlog;h=refs/heads/android-msm-2.6.34-test2
http://android.git.kernel.org/?p=kernel/experimental.git;a=shortlog;h=refs/heads/android-2.6.34-test2
http://git.kernel.org/?p=linux/kernel/git/stable/linux-2.6.34.y.git;a=summary
http://git.kernel.org/?p=linux/kernel/git/stable/linux-2.6.35.y.git;a=summary
http://android.git.kernel.org/?p=kernel/common.git;a=shortlog;h=refs/heads/android-2.6.35

——–

Instructions:
Flash the .zip through recovery

then

Install SetCPU 2.x (by coolbho)
Autodetect, Min: 122, Max: 576, onboot, ondemand
Do not enable or setup Advanced

Note:
If you are coming from a previous oc-uv kernel, then please go in to SetCPU and raise the min bar up and then down back to 122.

Optional: You can setup profiles, but if you receieve lag, please be sure that your device is not stuck on a low frequency due to one of the profiles you have set and or due to cpufreq and SetCPU ‘oddness’.

« »